1.8m Slotted Concrete Post

Rapid setting post hole concrete, suitable for fixing all types of wooden, metal and concrete posts.

Post Mix is a pre-blended, quick setting concrete mix, which sets in approximately 10 minutes after mixing with water (depending on ambient temperature).
Simply half fill the hole with water, then pour the post mix in.

Fencing contractors typically allow 1½ to 2 bags per fence post (this varies depending on the hole and post size).

We offer 33% discount on post-mix when you pay & collect in store!

Concrete gravel boards slot between concrete posts to give fence panels a level surface to sit on. It is beneficial to use gravel boards if the ground is sloping; the gravel board is dug into the ground to create a level surface instead of digging in the fence panel. Raising the panel on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 45mm x 150mm x 1829mm
- 20kg Each
- C50 Concrete (a strong mix)
- Two 5.5mm rebar set inside.

Concrete gravel boards slot between concrete posts to give fence panels a level surface to sit on. It is beneficial to use gravel boards if the ground is sloping; the gravel board is dug into the ground to create a level surface instead of digging in the fence panel. Raising the panel on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 45mm x 300mm x 1829mm
- 44kg Each
- C50 Concrete (a strong mix)
- Three 5.5mm rebar set inside.

45mm Fence Panel Clips; used to attach fence panels to wooden posts. Minimum of 4 clips needed per fence panel.

- Fits fence panels up to 45mm thick
- Galvanised Steel

2.4m slotted intermediate concrete post; fully slotted on both sides for timber fence panels and concrete gravel boards. Most fence panels will fit this post; check the slot dimensions below.

- Post Dimensions: 90mm x 110mm x 2400mm
- Slot Dimensions: 55mm (tapering to 50mm) x 23mm
- 46kg Each
- C50 Concrete (a strong mix)
- Four 5.5mm rebar set inside

A premium quality Overlap Panel which is built to last.

Height: 914mm (3')
Width: 1829mm (6')

- Fully pressure treated panels
- Nailed construction
- Straight-edge, horizontal, sawn-finish slats
- Five vertical battens on both sides (approx. 18 x 38mm)
- Framed top and bottom on both sides (approx. 18 x 38mm)
- Finished and protected with a top capping strip
- These panels look the same from both sides, perfect for shared boundaries
- Manufactured in the U.K.