2.4m Slotted Concrete End Post

Rapid setting post hole concrete, suitable for fixing all types of wooden, metal and concrete posts.

Post Mix is a pre-blended, quick setting concrete mix, which sets in approximately 10 minutes after mixing with water (depending on ambient temperature).
Simply half fill the hole with water, then pour the post mix in.

Fencing contractors typically allow 1½ to 2 bags per fence post (this varies depending on the hole and post size).

We offer 33% discount on post-mix when you pay & collect in store!

Concrete gravel boards slot between concrete posts to give fence panels a level surface to sit on. It is beneficial to use gravel boards if the ground is sloping; the gravel board is dug into the ground to create a level surface instead of digging in the fence panel. Raising the panel on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 45mm x 150mm x 1829mm
- 20kg Each
- C50 Concrete (a strong mix)
- Two 5.5mm rebar set inside.

2.4m slotted intermediate concrete post; fully slotted on both sides for timber fence panels and concrete gravel boards. Most fence panels will fit this post; check the slot dimensions below.

- Post Dimensions: 90mm x 110mm x 2400mm
- Slot Dimensions: 55mm (tapering to 50mm) x 23mm
- 46kg Each
- C50 Concrete (a strong mix)
- Four 5.5mm rebar set inside

Concrete gravel boards slot between concrete posts to give fence panels a level surface to sit on. It is beneficial to use gravel boards if the ground is sloping; the gravel board is dug into the ground to create a level surface instead of digging in the fence panel. Raising the panel on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 45mm x 300mm x 1829mm
- 44kg Each
- C50 Concrete (a strong mix)
- Three 5.5mm rebar set inside.

Timber batten is a general purpose building material that has many uses for trade and DIY.

- Fine-sawn finish
- Pressure treated green
- This batten does not comply with BS5534, we stock blue batten which does meet this grade.

125mm Feather Edge Boards are tapered boards that are vertically lapped to form a solid fence.
Feather-edge can also be fitted horizontally as a budget cladding.

- 125mm Board Width
- 10 boards needed per linear metre (25mm overlap)
- Cut from 22 x 125mm
- Finished size approx. 12mm on thick edge tapering to 6mm on thin edge
- Homegrown Spruce
- Sawn finish
- Pressure treated green