300mm Curved Rail Hook & Band Hinge Set R/H

Hex head coach screw, for heavy-duty applications. Suitable for fixing into timber, can fix into brickwork and masonry with an M8 plug . M8 washers sold separately.

- Length excludes 5mm bolt head
- Bright Zinc Plated finish (BZP)
- Pre-drill timber with 4 - 6mm pilot hole
- Hex Head fits a 13mm Spanner

30mm Fence Panel L-Clip, a useful panel clip for discreet fixing that can only be seen from one side. Can also be used to fix gravel boards, as well as many uses as a general purpose corner bracket.

- Angle: 30 x 30mm
- Height: 50mm
- Galvanised Steel

Rapid setting post hole concrete, suitable for fixing all types of wooden, metal and concrete posts.

Post Mix is a pre-blended, quick setting concrete mix, which sets in approximately 10 minutes after mixing with water (depending on ambient temperature).
Simply half fill the hole with water, then pour the post mix in.

Fencing contractors typically allow 1½ to 2 bags per fence post (this varies depending on the hole and post size).

We offer 33% discount on post-mix when you pay & collect in store!

A light duty fixing for jobs where speed of installation is important.
Hammer fixings work in a similar way to screws and plugs, the hammer fixing screw has a special thread that can be hammered into the plug and loosened / screwed out if required.

Installation:
Pre-drill a 10mm pilot hole through the item that you're fixing and into the masonry or brickwork. Lightly tap the fixing through the pilot hole with a hammer until the plug is flush. EG. if you're fixing a timber wall plate, the plug fits inside the timber as well as the wall. Once the plug is flush with the timber, hit the head of the screw harder to drive it into the plastic sleeve until tight.

Minimum fixing depth: 45mm

General purpose, pressure treated, sawn finish timber. Mainly used as fence posts but could have many other uses.

- Dimensions: 100 x 100mm x 1.8m
- Sawn Finish
- Homegrown Softwood, locally produced in the UK
- Pressure Treated - Green

This post support is designed to hold a 100 x 100mm square wooden post in position when it’s not possible to concrete a post into the ground. The bolt-clamp on the side of the post support ensures a quick and secure fit. The rectangular base plate enables flush fitting next to walls/obstructions, it's also a good fit when mounted on top of walls.

- Designed to fit 100 x 100mm square wooden posts
- Bolt-Grip post securing system
- Bolt down plate: 108mm x 205mm - flush fitting
- Bolt holes: 4 x 12mm Ø holes for bolting down the base
- Manufactured from 2mm thick steel
- Welded construction
- Galvanised finish for durability outdoors