4.0 x 60mm Superdrive Woodscrews - Box 200

125mm Feather Edge Boards are tapered boards that are vertically lapped to form a solid fence.
Feather-edge can also be fitted horizontally as a budget cladding.

- 125mm Board Width
- 10 boards needed per linear metre (25mm overlap)
- Cut from 22 x 125mm
- Finished size approx. 12mm on thick edge tapering to 6mm on thin edge
- Homegrown Spruce
- Sawn finish
- Pressure treated green

Rapid setting post hole concrete, suitable for fixing all types of wooden, metal and concrete posts.

Post Mix is a pre-blended, quick setting concrete mix, which sets in approximately 10 minutes after mixing with water (depending on ambient temperature).
Simply half fill the hole with water, then pour the post mix in.

Fencing contractors typically allow 1½ to 2 bags per fence post (this varies depending on the hole and post size).

We offer 33% discount on post-mix when you pay & collect in store!

Arris rail is a triangular shaped fencing rail for use with feather edge fencing. This rail is designed to fit into notched posts or can be attached to standard posts with an arris rail bracket. Arris rail can also be used (under felt) around the edges of flat roofing, or as corner reinforcement when building wooden crates etc.

- Cut from 75 x 75mm (Square)
- Rail Dimensions: 74 x 74mm x 2.4m, 105mm on longest edge
- Sawn Finish
- Homegrown Softwood, locally produced in the UK
- Pressure Treated - Green

Planed finish fencing rails with two 45° chamferred corners. Ideal for use with our planed picket slats with a smooth, premium finish but has many other uses including deck boards and bench slats.
These fencing rails are pressure treated green; 15 year Treat-Right Warranty.

- Planed all round timber, with two 45° chamfered corners
- Machined from: 32 x 100mm x 2.4m
- Finished Size: 28 x 95mm x 2.4m
- High quality, slow grown redwood
- Pressure Treated green, 15 year Treat-Right Warranty, details in Downloads tab below

A light duty fixing for jobs where speed of installation is important.
Hammer fixings work in a similar way to screws and plugs, the hammer fixing screw has a special thread that can be hammered into the plug and loosened / screwed out if required.

Installation:
Pre-drill a 8mm pilot hole through the item that you're fixing and into the masonry or brickwork. Lightly tap the fixing through the pilot hole with a hammer until the plug is flush. EG. if you're fixing a timber wall plate, the plug fits inside the timber as well as the wall. Once the plug is flush with the timber, hit the head of the screw harder to drive it into the plastic sleeve until tight.

Minimum fixing depth: 45mm

General purpose, pressure treated, sawn finish timber. Mainly used as fence posts but could have many other uses.

- Dimensions: 75 x 75mm x 2.4m
- Sawn Finish
- Homegrown Softwood, locally produced in the UK
- Pressure Treated - Green