Double Shovelholer With Wooden Handles

Concrete gravel boards slot between concrete posts to give fence panels a level surface to sit on. It is beneficial to use gravel boards if the ground is sloping; the gravel board is dug into the ground to create a level surface instead of digging in the fence panel. Raising the panel on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 45mm x 150mm x 1829mm
- 20kg Each
- C50 Concrete (a strong mix)
- Two 5.5mm rebar set inside.

A heavy-duty Close Board Panel which is built to last. A sturdy option suitable for exposed, windy areas. Previously known as the Suffolk panel.

Height: 1524mm (5')
Width: 1829mm (6')

- Fully pressure treated fence panels,
- ex. 22 x 125mm Feather Edge slats with fine-sawn finish,
- Sturdy jointed framework on the back of the panel,
- Nailed construction; stainless steel fixings,
- Finished and protected with a top capping strip,

Our 125mm feather Edge Boarding will match these panels and can be purchased separately to make your own non-standard panel sizes if needed.

Rapid setting post hole concrete, suitable for fixing all types of wooden, metal and concrete posts.

Post Mix is a pre-blended, quick setting concrete mix, which sets in approximately 10 minutes after mixing with water (depending on ambient temperature).
Simply half fill the hole with water, then pour the post mix in.

Fencing contractors typically allow 1½ to 2 bags per fence post (this varies depending on the hole and post size).

We offer 33% discount on post-mix when you pay & collect in store!

Slotted intermediate concrete "H" post; fully slotted on both sides for timber fence panels and concrete gravel boards. Most fence panels will fit this post; check the slot dimensions below.

- Post Dimensions: 90mm x 110mm x 2100mm
- Slot Dimensions: 55mm (tapering to 50mm) x 23mm
- 40kg Each
- C50 Concrete (a strong mix)
- Four 5.5mm rebar set inside

Slotted Concrete End Post; fully slotted on one side for timber fence panels and concrete gravel boards. Most fence panels will fit this post; check the slot dimensions below.

- Post Dimensions: 90mm x 110mm x 2400mm
- Slot Dimensions: 55mm (tapering to 50mm) x 23mm
- 50kg Each
- C50 Concrete (a strong mix)
- Four 5.5mm rebar set inside