Hitachi DH24PX/J1 - 240V 3 Mode SDS+ Hammer Drill 730W 2.7J

50mm Fence Panel Clips; used to attach fence panels to wooden posts. Minimum of 4 clips needed per fence panel.

- Fits fence panels up to 50mm thick
- Galvanised Steel

A self tapping bolt suitable for concrete, stone, brick, marble, wood and block (solid or hollow). Safe anchorage achieved without the need of high tightening forces. Can be removed and re-fixed into the same hole, providing the thread is correctly aligned. No expansion forces enables close to the edge fixing.

Drill Bit Dia. - 10mm
Anchor Length - 130mm
Washer Size - 12mm (M12)
Min Hole Depth - 70mm
Min Over Drill Depth - 20mm
Min. Embed Depth - 50mm
Max. Fixture Thickness - 80mm
Drill Bit Dia. for clearance - 12mm (to prevent binding when tightening bolt)
Head Type - Hex Head, 17mm (Across Flats)
Driver Type - Impact driver, socket, spanner
Max Tightening Torque - 60Nm

A heavy steel washer, for general use with bolts and threaded bar (studding).
BZP (Bright Zinc Plate) finish.

Dimensions: 2mm x 28mm Diameter
13mm Bolt Hole: To suit M12 thread

Planed finish timber post cap for 100 x 100mm posts, pressure treated green. Protects post ends from weather and provides a smart finishing touch.

- Dimensions: 50mm (middle) x 125mm x 125mm
- Decorative chamfer on four sides
- Pressure treated
- Includes double ended screw (attached)

Sawn timber post, pressure treated green. Mainly used for post & rail fencing, these posts have one flat end & one 30° back-weathered end to help prevent the top from rotting by allowing water to run off. Please note; the stated length includes the weathered top.

- 75 x 125mm x 1.8m Timber Post
- Homegrown softwood
- Fully incised surface for improved treatment penetration
- UC4 Pressure Treatment - Green
- 30° back-weathered top

The Neris fence panel is a good quality, well-made, decorative fence panel. It looks the same from both sides; perfect for shared boundaries. These panels are constructed with ‘hit & miss’ slats that allow wind to pass through. This panel has a smooth machined finish and is pressure treated green.

Height; middle of curve: 1800mm (approx. 6')
Height; edge of curve: 1600mm
Width: 1800mm
Depth: 45mm

Please note this panel is 1800mm wide, not 1829mm (6’), you can increase the panel width to 1829mm by attaching panel packing strips, sold separately.