Oval Padbolt - Galvanised

125mm Feather Edge Boards are tapered boards that are vertically lapped to form a solid fence.
Feather-edge can also be fitted horizontally as a budget cladding.

- 125mm Board Width
- 10 boards needed per linear metre (25mm overlap)
- Cut from 22 x 125mm
- Finished size approx. 12mm on thick edge tapering to 6mm on thin edge
- Homegrown Spruce
- Sawn finish
- Pressure treated green

Rapid setting post hole concrete, suitable for fixing all types of wooden, metal and concrete posts.

Post Mix is a pre-blended, quick setting concrete mix, which sets in approximately 10 minutes after mixing with water (depending on ambient temperature).
Simply half fill the hole with water, then pour the post mix in.

Fencing contractors typically allow 1½ to 2 bags per fence post (this varies depending on the hole and post size).

We offer 33% discount on post-mix when you pay & collect in store!

125mm Feather Edge Boards are tapered boards that are vertically lapped to form a solid fence.
Feather-edge can also be fitted horizontally as a budget cladding.

- 125mm Board Width
- 10 boards needed per linear metre (25mm overlap)
- Cut from 22 x 125mm
- Finished size approx. 12mm on thick edge tapering to 6mm on thin edge
- Homegrown Spruce
- Sawn finish
- Pressure treated green

Carriage Bolt; cup square hex, 16mm mushroom head, BZP finish (Bright Zinc Plate). Designed for bolting through timber.

Square hex refers to the square section attached to the mushroom head, this sinks into timber and stops the bolt from spinning when the nut is tightened.

Supplied with one standard hex nut, washers sold separately.

125mm Feather Edge Boards are tapered boards that are vertically lapped to form a solid fence.
Feather-edge can also be fitted horizontally as a budget cladding.

- 125mm Board Width
- 10 boards needed per linear metre (25mm overlap)
- Cut from 22 x 125mm
- Finished size approx. 12mm on thick edge tapering to 6mm on thin edge
- Homegrown Spruce
- Sawn finish
- Pressure treated green

450mm Metal Peg, also known as a metal fence pin. This sturdy steel peg is suitable for path and edging, and for securing fencing gravel boards. The small profile of the peg makes it easier to drive into hard ground than the larger timber equivalent.

- 25mm x 25mm Steel Angle
- 2.0mm Thick Steel
- Galvanised
- Pointed to drive
- Three 6mm diameter holes in the corner for fixings