Fixings & Metalwork

Hex head coach screw, for heavy-duty applications. Suitable for fixing into timber, can fix into brickwork and masonry with an M10 plug. M10 washers sold separately.

- Length excludes 7mm bolt head
- 65mm screw thread, 15mm unthreaded
- Bright Zinc Plated finish (BZP)
- Pre-drill timber with 6 - 8mm pilot hole
- Hex Head fits a 17mm Spanner

Metal brace for strengthening corners. Can be used for internal or external corners.
Pre-drilled for use with countersunk screws, countersunk on both sides of fixing hole.
Bright Zinc Plated (BZP) for corrosion resistance.

Thickness: 1.8mm
Width: 20mm
Length: 75mm x 75mm
Drill Holes: 5.0mm (x6)

Metal corner plate for strengthening corners. Pre-drilled fixing holes for use with countersunk screws.
Bright Zinc Plated (BZP) for corrosion resistance.

Thickness: 2.0mm
Width: 16mm
Length: 75mm x 75mm
Fixing Holes: 5.5mm (x4)

Carriage Bolt; cup square hex, 20mm mushroom head, BZP finish (Bright Zinc Plate). Designed for bolting through timber.

Square hex refers to the square section attached to the mushroom head, this sinks into timber and stops the bolt from spinning when the nut is tightened.

Supplied with one standard hex nut, washers sold separately.

A light duty fixing for jobs where speed of installation is important.
Hammer fixings work in a similar way to screws and plugs, the hammer fixing screw has a special thread that can be hammered into the plug and loosened / screwed out if required.

Installation:
Pre-drill a 8mm pilot hole through the item that you're fixing and into the masonry or brickwork. Lightly tap the fixing through the pilot hole with a hammer until the plug is flush. EG. if you're fixing a timber wall plate, the plug fits inside the timber as well as the wall. Once the plug is flush with the timber, hit the head of the screw harder to drive it into the plastic sleeve until tight.

Minimum fixing depth: 45mm