Gates & Gate Fittings

19mm gate hanger designed to be built into brickwork. This item is galvanised for corrosion resistance.

Galvanised for corrosion resistance, this 19mm gate pin has 2 bolt holes on a 50 x 200mm plate.

Galvanised for corrosion resistance, this 19mm gate pin has 4 bolt holes for a very secure fixing.

This 19mm hook to drive is normally used for fitting the bottom part of a standard field gate hinge to a timber gate post. The 19x19x175mm square spike is designed to be driven in with a club/ sledge hammer. This enables the fitter to easily adjust the length of the hook in order to make the gate plumb. A pilot hole must be drilled to avoid splitting the post. Galvanised to prevent rust.

This adjustable gate hanger has a 19mm pin and is galvanised for corrosion resistance. Typically used for fitting pairs of wooden five bar gates to timber gate posts, the adjustable hook length enables the fitter to easily make sure that the gates line up perfectly in the middle. The 100x100mm fixing plate has four holes for screws or bolts.