Gates & Gate Fittings

This 19mm hook to drive is normally used for fitting the bottom part of a standard field gate hinge to a timber gate post. The 19x19x175mm square spike is designed to be driven in with a club/ sledge hammer. This enables the fitter to easily adjust the length of the hook in order to make the gate plumb. A pilot hole must be drilled to avoid splitting the post. Galvanised to prevent rust.

Galvanised for corrosion resistance, this 19mm gate pin has 4 bolt holes for a very secure fixing.

Galvanised for corrosion resistance, this 19mm gate pin has 2 bolt holes on a 50 x 200mm plate.

19mm gate hanger designed to be built into brickwork. This item is galvanised for corrosion resistance.

This hook to screw has a 19mm pin to fit a standard field gate hinge, to a timber gate post. The pin has a hole at the top to fit a small bolt to stop the gate being lifted off the hinge. The 18x190mm screw thread enables the fitter to easily adjust the length of the hook in order to make the gate plumb, which is ideal if re-using old posts that have moved over time. A pilot hole must be drilled to avoid splitting the post. Galvanised to prevent rust.