Masonry Fixings

A self tapping bolt suitable for concrete, stone, brick, marble, wood and block (solid or hollow). Safe anchorage achieved without the need of high tightening forces. Can be removed and re-fixed into the same hole, providing the thread is correctly aligned. No expansion forces enables close to the edge fixing.

Drill Bit Dia. - 8mm
Anchor Length - 75mm
Washer Size - 10mm (M10)
Min Hole Depth - 55mm
Min Over Drill Depth - 15mm
Min. Embed Depth - 40mm
Max. Fixture Thickness - 35mm
Drill Bit Dia. for clearance - 10mm (to prevent binding when tightening bolt)
Head Type - Hex Head, 15mm (Across Flats)
Driver Type - Impact driver, socket, spanner
Max Tightening Torque - 40Nm

A light duty fixing for jobs where speed of installation is important.
Hammer fixings work in a similar way to screws and plugs, the hammer fixing screw has a special thread that can be hammered into the plug and loosened / screwed out if required.

Installation:
Pre-drill a 10mm pilot hole through the item that you're fixing and into the masonry or brickwork. Lightly tap the fixing through the pilot hole with a hammer until the plug is flush. EG. if you're fixing a timber wall plate, the plug fits inside the timber as well as the wall. Once the plug is flush with the timber, hit the head of the screw harder to drive it into the plastic sleeve until tight.

Minimum fixing depth: 45mm

A self-tapping Masonry Screw for brick and concrete, a popular fixing to fit window frames. An easy to use fixing that does not require plastic plugs, it has a high resistance to fire compared to nylon fixings. This screw is a friction fixing which minimises expansion stress in the base material, this allows fixing near to the edge, and gives greater loading performance than most nylon fixings.
To use: pre-drill a 6mm pilot hole, use a drill or impact driver fitted with T30 bit to drive the screw in.

T30 bit and white cover caps included when bought in box quantities of 100.

Drill Bit Dia. - 6mm
Min. Embed Depth - 45mm
Head Type - T30 Torx
Driver Type - Drill / Impact Driver

A light duty fixing for jobs where speed of installation is important.
Hammer fixings work in a similar way to screws and plugs, the hammer fixing screw has a special thread that can be hammered into the plug and loosened / screwed out if required.

Installation:
Pre-drill a 10mm pilot hole through the item that you're fixing and into the masonry or brickwork. Lightly tap the fixing through the pilot hole with a hammer until the plug is flush. EG. if you're fixing a timber wall plate, the plug fits inside the timber as well as the wall. Once the plug is flush with the timber, hit the head of the screw harder to drive it into the plastic sleeve until tight.

Minimum fixing depth: 45mm

A self-tapping Masonry Screw for brick and concrete, a popular fixing to fit window frames. An easy to use fixing that does not require plastic plugs, it has a high resistance to fire compared to nylon fixings. This screw is a friction fixing which minimises expansion stress in the base material, this allows fixing near to the edge, and gives greater loading performance than most nylon fixings.
To use: pre-drill a 6mm pilot hole, use a drill or impact driver fitted with T30 bit to drive the screw in.

T30 bit and white cover caps included when bought in box quantities of 100.

Drill Bit Dia. - 6mm
Min. Embed Depth - 45mm
Head Type - T30 Torx
Driver Type - Drill / Impact Driver