Fencing Materials

Diamond Trellis panels are constructed using good quality planed battens, they are framed all round with rebated framing. This attractive trellis panel obscures visibilty between boundaries without the need of a solid fence or the need to block out daylight. This product is pressure treated green.

- Width: 1829mm ( 6' )
- Height: 550mm (Middle) → 450mm (Edge)
- Hole Size: (approx.) 50 x 50mm.
- Frame Thickness: 30mm
- Pressure Treated

These concrete gravel boards are designed to be used with recessed concrete posts. Concrete gravel boards for recessed posts give feather edge fencing a level surface to sit on. Raising feather edge boards on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 50mm x 150mm x 2400mm
- 40kg Each
- C50 Concrete (a strong mix)
- Two 5.5mm rebar set inside
- One 14mm diameter hole in the middle to attach a support post (if required)

Welded wire mesh is produced using wire that is welded on every joint, this makes the product very strong while remaining flexible enough to shape. Galvanised for outdoor use, ideal for use in animal cages & runs etc.

Height: 900mm
Length: 6m
Mesh size: 13mm x 25mm
Wire gauge: 1.0mm
Galvanised
Manufactured to BS EN 10223-4 1998

Square Trellis Panels are sturdy and built to last; made from sawn finish 19 x 38mm batten; nailed construction. Pressure treated Green.

- Width: 1829mm ( 6’ )
- Height: 1829mm ( 6’ )
- Hole Size: 110 x 110mm (approx.)
- 19 x 38mm Sawn Batten
- Nailed Construction
- Pressure Treated Green

A general purpose straining wire, mainly used for fencing purposes. Can be shaped by hand and cut with wire cutters.

- 2.5mm Overall Thickness (including galvanised coating)
- 10kg Roll (approx. 260 meters)
- Galvanised Finish
- Manufactured to BS 4102
- Galvanised to BS EN 10244-2

A general purpose straining wire, mainly used for fencing purposes. Can be shaped by hand and cut with heavy duty wire cutters.

- 3.15mm Overall Thickness (including galvanised coating)
- 10kg Roll (approx. 164 meters)
- Galvanised Finish
- Manufactured to BS 4102
- Galvanised to BS EN 10244-2

Slotted Concrete End Post; fully slotted on one side for timber fence panels and concrete gravel boards. Most fence panels will fit this post; check the slot dimensions below.

- Post Dimensions: 90mm x 110mm x 2700mm
- Slot Dimensions: 55mm (tapering to 50mm) x 23mm
- 56kg Each
- C50 Concrete (a strong mix)
- Four 5.5mm rebar set inside

A heavy duty Close Board fence panel. Made in the U.K. using pressure treated, home grown softwoood.

Height: 1524mm (5')
Width: 1829mm (6’)

- 47 x 30mm framework
- ex. 22 x 125mm feather edge
- Nailed construction
- Pressure Treated green
- Finished with planed capping

A premium quality Overlap Panel which is built to last.

Height: 1676mm (5'6")
Width: 1829mm (6')

- Fully pressure treated panels
- Nailed construction
- Straight-edge, horizontal, sawn-finish slats
- Five vertical battens on both sides (approx. 16 x 38mm)
- Framed top and bottom on both sides (approx. 16 x 38mm)
- Finished and protected with a top capping strip
- These panels look the same from both sides, perfect for shared boundaries
- Manufactured in the U.K.

A premium quality Overlap Panel which is built to last.

Height: 1829mm (6')
Width: 1829mm (6')

- Fully pressure treated panels
- Nailed construction
- Straight-edge, horizontal, sawn-finish slats
- Five vertical battens on both sides (approx. 16 x 38mm)
- Framed top and bottom on both sides (approx. 16 x 38mm)
- Finished and protected with a top capping strip
- These panels look the same from both sides, perfect for shared boundaries
- Manufactured in the U.K.

Diamond Trellis panels are constructed using good quality planed battens, they are framed all round with rebated framing. This attractive trellis panel obscures visibilty between boundaries without the need of a solid fence or the need to block out daylight. This product is pressure treated green.

- Width: 1829mm ( 6' )
- Height: 900mm
- Hole Size: (approx.) 50 x 50mm.
- Frame Thickness: 30mm
- Pressure Treated

A heavy duty Close Board fence panel. Made in the U.K. using pressure treated, home grown softwoood.

Height: 1676mm (5'6")
Width: 1829mm (6’)

- 47 x 30mm framework
- ex. 22 x 125mm feather edge
- Nailed construction
- Pressure Treated green
- Finished with planed capping

These concrete gravel boards are designed to be used with recessed concrete posts. Concrete gravel boards for recessed posts give feather edge fencing a level surface to sit on. Raising feather edge boards on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 50mm x 150mm x 3000mm
- 52kg Each
- C50 Concrete (a strong mix)
- Two 5.5mm rebar set inside
- One 14mm diameter hole in the middle to attached a support post (if required)

A heavy duty Close Board fence panel. Made in the U.K. using pressure treated, home grown softwoood.

Height: 1829mm (6')
Width: 1829mm (6’)

- 47 x 30mm framework
- ex. 22 x 125mm feather edge
- Nailed construction
- Pressure Treated green
- Finished with planed capping

Heavy duty concrete fence post for feather-edge fencing. This post has a weathered top; 3 recesses with bolt holes for fencing rails and bolt holes at the bottom to fit a gravel board. View image 2 for dimensions. This post is suitable for 1.35m feather edge boarding with a 150mm gravel board.

- Post Length: 2205mm
- Suitable for 1.35m Feather Edge + 150mm Gravel Board
- Three Recesses for 47 x 75mm Rail
- Use M8 x 180mm bolts to attach rails & gravel boards
- 67kg Each