Gates & Gate Fittings

Available painted black or hot dip galvanised to ensure resistance to corrosion & rust, these hook & band hinges are ideal for hanging heavy duty gates & doors.
The crank allows the gate to sit flush with the post if hanging on the front or the back of the post.

As a general rule we recommend using hinges that cover half the width of the gate/door.
Fixings sold separately.

Twisted black ring latch that can be operated from both sides. Suitable for gates & doors up to 100mm thick (thinner gates will require the spindle to be cut down).
Fixings & fitting instructions included.

Galvanised for durability, these twisted ring latches that can be operated from both sides. Suitable for gates & doors up to 100mm thick (thinner gates will require the spindle to be cut down).
Fixings & fitting instructions included.

Spring loaded sliding bolt, ideal for use on gates, garage doors.
Fixings included in the pack.

The use of drop bolts is recommended on most gate installations as it helps to prevent the gate from twisting at the bottom.
The bolt can also be used to hold the gate open if required.

The New Zealand (NZ) Gate Fastener is a basic form of gate catch, typically used to secure field gates. The heavy-duty fastener hook has a spring loaded catch to prevent accidental opening. For extra security a padlock (not included) could be attached through the chain. Galvanised finish.

Staple:
Diameter: 8mm
Length: 65mm
Width: 45mm

Chain:
Length: 1000mm
Links: 6mm diameter x 25mm x 30mm

Fastener:
Length: 100mm
Diameter: 12mm

Surface mounted rimsashlock. Fixings & 2 keys included in the pack.
The spindle is included with the handle.

Padlockable sliding gate bolt.
All fixings included.

Galvanised monkey tail bolt, can be used for securing the bottom of a door/gate into the ground or the top into the door frame.

A galvanised metal bracket set designed to hold a removable, sliding fence rail. Often used as a cheaper alternative to a field gate. A rotating catch is incorporated, this slots into a notch cut into the sliding rail. The catch prevents the rail being accidently removed when animals push against it.

Maximum rail size: 50mm x 110mm
Fixings included

With a textured dull black finish, this suffolk latch gives a decorative detail to gates & doors. Can be operated from both sides.
All fixings included.

A Throw Over Gate Loop with lifting handle is used to secure a pair of wooden five bar gates in the middle when in the closed position. The galvanised gate loop is fitted to the top rail of the closing gate with the included carriage bolt. For best results; drop bolts should also be fitted to secure the bottom of both gates (sold separately).

Overall Length: 350mm
Maximum Top Rail Width: 75mm
Minimum Top Rail Depth: 75mm
Galvanised finish
Carriage bolt included

Used when you need to close the gate in between the posts, the morticed field gate latch is designed to fit a 75mm stile.

Foot operated latch for stable doors & field gates, allowing entry when your hands are full.
All fixings included.

Electro-galvanised to ensure resistance to corrosion & rust, these tee hinges are ideal for hanging our timber garden gates & shed doors.
As a general rule we recommend using hinges that cover half the width of the gate/door.

All fixings are included.