Gates & Gate Fittings

This adjustable gate hanger has a 19mm pin and is galvanised for corrosion resistance. Typically used for fitting pairs of wooden five bar gates to timber gate posts, the adjustable hook length enables the fitter to easily make sure that the gates line up perfectly in the middle. The 100x100mm fixing plate has four holes for screws or bolts.

This 19mm hook to drive is normally used for fitting the bottom part of a standard field gate hinge to a timber gate post. The 19x19x175mm square spike is designed to be driven in with a club/ sledge hammer. This enables the fitter to easily adjust the length of the hook in order to make the gate plumb. A pilot hole must be drilled to avoid splitting the post. Galvanised to prevent rust.

Galvanised for corrosion resistance, this 19mm gate pin has 4 bolt holes for a very secure fixing.

Galvanised for corrosion resistance, this 19mm gate pin has 2 bolt holes on a 50 x 200mm plate.

19mm gate hanger designed to be built into brickwork. This item is galvanised for corrosion resistance.

This hook to screw has a 19mm pin to fit a standard field gate hinge, to a timber gate post. The pin has a hole at the top to fit a small bolt to stop the gate being lifted off the hinge. The 18x190mm screw thread enables the fitter to easily adjust the length of the hook in order to make the gate plumb, which is ideal if re-using old posts that have moved over time. A pilot hole must be drilled to avoid splitting the post. Galvanised to prevent rust.

This 19mm hook to bolt is normally used for fitting the top part of a standard field gate hinge to a timber gate post. Suitable for posts between 125mm to 200mm. Galvanised to prevent rust.

This 19mm hook to bolt is used for hanging field gates from a brick pillar without having to secure timber to the pillar first.

Padlockable sliding gate bolt.
All fixings included.

Padlockable sliding gate bolt.
All fixings included.

Foot operated gate / door stop.

Galvanised for durability, these heavy duty twisted ring latches that can be operated from both sides. Suitable for gates & doors up to 100mm thick (thinner gates will require the spindle to be cut down).
Fixings & fitting instructions included.

- Nationwide parcel delivery service available on this product. Call or email us for details

Light cabin hooks with all fixings included. Used for holding gates / doors open.

Light cabin hooks with all fixings included. Used for holding gates / doors open.

Designed for field and farm gates, these gate eyes are compatible with our wide range of 19mm gate hooks.
When using for steel gates, adjustable gate eyes can be bolted directly through the gate stile & the included nuts tightened each side, if you are hanging timber gates an adjustable bottom fitting is commonly used instead.